|
Bryco Industrial Service is a profilometer repair and rebuild specialist. We have been saving money for clients by servicing instead of replacing the profilometer units for over two decades. |
Attention Customers: Bryco Industrial does not charge for evaluations. Send your damaged or uncalibrated profilometers for a no-hassle quote and until approval is given, no repairs will begin.
We repair all major Profilometer brands including Mahr Federal, Fowler and Mitutoyo. |
|
|
|
PS1 Probe Repair |
Pocket Surf Repair |
|
|
Perthometer Repair |
Pocket Surf Probes |
|
|
Mitutoyo SJ201 Probe |
Perthometer Pickup Repair |
|
|
PS1 Repair |
Mitutoyo SJ201 Repair |
|
Surface Roughness Tester Repair |
Profilometers are used to determine the surface roughness of many surfaces. Since these devices are small and completely portable, they can be used with ease in a variety of environments including shop floors, in the laboratory or on the job. Profilometers can be used upside down, horizontal or vertical and in hard-to reach surfaces because of their small size. |
Profilometers are used to determine the surface roughness of many surfaces. Since these devices are small and completely portable, they can be used with ease in a variety of environments including shop floors, in the laboratory or on the job. Profilometers can be used upside down, horizontal or vertical and in hard-to reach surfaces because of their small size. |
Trust Bryco Industrial Service to repair and/or rebuild even the most delicate instruments. Give us a call today at 724-809-7909 for more information. |
Profilometer Repair repairs and rebuilds your Mahr Federal and Fowler pocket surf models I, II and III. |
Pocket-sized economically priced, completely portable instrument which performs traceable surface roughness measurements on a wide variety of surfaces; can be used confidently in production, on the shop floor and in the laboratory. |
- Solidly built, with a durable cast aluminum housing, to provide years of accurate, reliable surface finish gaging.
- Can be used to measure any one of four, switch-selectable, parameters: Ra , Rmax/Ry , Rz.
- Selectable traverse length 1, 3 or 5 cut-offs of 0.8 mm/.030 in.
- Operates in any position “ horizontal, vertical, and upside down
- Easy-to-read LCD readout presents the measured roughness value, in microinches or micrometers, within half a second after the surface is traversed.
- Out-of-range (high or low) and battery low signals are also displayed.
- Four switchable probe positions “axial (folded) or at 90°, 180° or 270°
- Even difficult-to-reach surfaces such as inside and outside diameters are accessible.
- Integrated data output for SPC-processing units that is compatible with the most common data processing systems.
|
|
|